Apply Finishing Plaster On The Wall

Here are my thought about apply finishing plaster on the wall.

The cast is a mixture of sand and aggregates with cement or other binding materials eligible. This type of finish is the most commonly applied to walls or concrete surfaces. After applying other finishes on walls, such as paints or coatings can be applied. The thickness is usually on the surface but should not be very dense. This is due to the fact that does not adhere well to the wall. Plaster must be washed thoroughly after being applied.

Preparation of gypsum is very important. This phase begins with the linearity of the material and masonry plumbness. Fix for ten to fifteen millimeters of tacos or mounting blocks and well aligned. Use a straightedge and spirit level to check over righteousness. Place marks on the wall at least ten, at least in principle, bottom and middle rows. A mixture of cement and sand to give coherence to work with water. Moisten the surface of the wall and before the start.

The drywall starts mixing the mortar with water to make a paste. Use a steel float to put it on the wall. Apply to cover all blocks of wood. Malta Apply a little "dry and use the ruler to make the mixture too much. Pull diagonally, vertically and horizontally to expose the markers. Use a floating timber with a mixture of rubbing the entire surface. Use a ruler to check linearity and the square to come, have ninety degrees.

After confirming that the cast is relatively dry, remove the markers and fill the slot with Malta. Brand grout and apply with a steel float. Paste the entire wall to his blanket. Use the forward and backward strokes to have a smooth surface. Make sure the corners are square and horizontal angles between the points of base and cornice. Let dry for at least seven days straight swimmers. After his other finishes such as paint is dry.