Painting your plaster walls

Here are my thoughts on painting your plaster walls.

Before we know will continue followed, all fresh plaster patches, as seen by the repair of cracks, a layer of shellac to keep the two layers of paint or flat, can be diluted with turpentine. If this is not the brightness or "bright" spots in the surface layer of shellac has been applied where. A sustainable and paint is better, the suction is gone until the new patch. However, this requires more time, because paint dries much more slowly than shellac. Old plaster require the use of linseed oil, turpentine and fill with a little bit drier, the cracks very low.

Old plaster applied requires only two layers of plaster on three shifts. Before starting to paint the wall or ceiling, make sure the floor is completely covered. A scaffold must be in place and secured. When painting ceilings, until the first drop of 5-inch wall brush (painting) at a depth of about 1 ½ inches. Tap the brush on the side of the pot to remove the paint before brushing the excess paint on the ceiling. Do not wear too much on the brush as this is the color of the bottom of the brush and grip strength.

If the brush has to be responsible, clean, by adding them to the edge of the pot, and on the brush. Spread the paint evenly, do not count on "vacation" or strips of brush. Note that the last layer contains no oil. As linseed oil tends to yellow in color, on white or very easily recognizable walls and ceilings. Add a few drops of blue with white paint to hide the yellowing. Irregular yellow color should be avoided, even if you do not paint the shadows of the yellow room, depending on your plumbing fixtures, infrared sauna or steam shower.

If you plan to use the flat ceiling finish (third layer must be flat) take care to avoid the appearance of the towers. Considering that oil tanks can be manufactured and covered large areas, can not bowl this freedom, because it is fast. Start painting the same as the second layer, but not to a width of more than 1 inch. The brush, without stirring with her and melt into a semi-circular. Continue on the other side is coated in the same way. Return without wasting too much time, you finish the first part to renew the chamber, then proceed as before.

No time to waste, because the board faster than seven liters of gelatin in cold ice is steam shower, tub or swim spa. Do not try to mix one part is completed, the color, with fixed, increases the cleaning or drying in a bright place to leave, that the arrival in March. If the ceiling is very high, you do not work alone. Both should be the job for the best results. With two men on the scaffold, we will start to end and another will start in the middle.

This will hurt them from one another by moving to prevent the other lane, and the possibility of a double weight in the middle of the scaffolding, which can reduce turn out to be disastrous. Painted plastered walls with a brush 4 and a half inches instead of 5-inch brush for the recommended limits. Insert the STAIRS, so that the table will be started in the upper left corner of the room below the molding frame. Dip the brush into the paint about 1 ½ inches deep, he taps next to the pot, brush and painting with downward to cover the rough surface.

Follow mixing and smoothing the paint slightly up and down strokes. Further down on the base plate, then again, joining the first section. Continue to have the piece is coated. Even if you are not just a bathroom cabinet discount vanity bath accessories bathroom painted wood, it is always recommended to do more than one level.

When the final coat is flat, do not extend to a width of more than 1 cm at a time as fast court sets. From the molded image as in the previous coats, lies in the rapid and nearly a distance of about 1 cm wide. Blend it in a semicircle. Continue down to the baseboard. With as little time as possible accession of the head, takes care of the first banks.